WoodPlus Ultra 10 | 100% Acrylic Translucent Coating, for Vertical Wood Surfaces: Log Homes, Timber Frame Homes, Wood Siding and Fences

Description

WoodPlus Ultra 10 is a 100% Acrylic high film forming translucent coating designed for use on exterior vertical wood surfaces.

Ultra 10 is non-hazardous, contains no solvents and has low emissions (< 10g/L VOC). The translucent satin finish provides for full wood grain visibility and is specifically formulated with high quality trans-oxide pigments to provide optimal UV protection.

Ultra 10 provides a breathable film that provides excellent adhesion as well as an exceptional barrier against the elements.

What are the Advantages of using WoodPlus Ultra 10?

• Designed for High Performance in any Climate
• Beautiful Satin Finish
• Outstanding UV Protection
• High Quality Trans-Oxide Pigments Protect Against Color Change
• Excellent Physical Wear Protection
• No Primer Needed
• Easy Application
• Quick Drying
• Superior Adhesion
• Excellent Color and Gloss Retention
• Breathable Finish

What are the Recommended Exterior Uses for WoodPlus Ultra 10?

• Log Homes
• Timber Frame Homes
• Wood Siding
• Sheds
• Fences

Colors

 

Coverage

Surface First Coat	Second Coat
Smooth Wood 300-400 SF per Gallon	400-500 SF per Gallon
Resawn Wood 200-300 SF per Gallon	300-400 SF per Gallon

Note: The above coverage is approximate and may vary due to surface porosity of the substrate.

What Temperature Range is the Best for WoodPlus Ultra 10 Application?

WoodPlus Ultra 10 should be applied at temperatures between 50-90° F (10-32° C).

How Do You Prepare Your Wood to Apply WoodPlus Ultra 10?

1. Wood must be clean, dust free, and dry with a moisture content of <19%.
2. Remove all traces of dirt, wax, grease, mold and mildew.
3. Remove mill glaze on smooth lumber by sanding with 60-80 grit sand paper or by cleaning with a sodium percarbonate cleaner such as KleenStart or CPR.

Application Instructions

• WoodPlus Ultra 10 is ready to use.
• Stir WoodPlus Ultra 10 thoroughly prior to and during use.
• Do not apply WoodPlus Ultra 10 in direct sunlight or are hot to the touch.
• WoodPlus Ultra 10 can be applied with a brush, roller or a spray gun.
• Always back brush WoodPlus Ultra 10 that has been applied with an airless sprayer.
• Apply WoodPlus Ultra 10 in the direction of the grain, completing one full board at a time.
• Maintain a wet edge and saturate any open cut or cut ends of boards.
• Do not apply WoodPlus Ultra 10 in wet weather or when inclement weather is imminent.

What is the Drying Time for WoodPlus Ultra 10?

• WoodPlus Ultra 10 dries to the touch in 1 hour.
• A second Coat can be applied 2–4 hours after the first coat.
• Application equipment cleans up with warm soapy water.

 

---

Safety Data Sheet

Click here for this product’s Safety Data Sheets (SDS)